Straight Side Press – BSS Series

bss-series

Features
FRAME:
All Press frames are fabricated from extra thick high tensile steel plate and reinforced by heavy ribbing to assure the least deflection against full load. The frame element are thermally stress relieved for maintaining accuracy over.
CRANK SHAFT AND BEARINGS:
Eccentric shaft is machined from normalized carbon steel forged. It has been ground finished on bearing surfaces. Heavy walled phosphorus bronze Bearings used for long run.
SLIDE AND GUIDES:
Heavy duty cast iron slide runs in long cast iron guides and bearing surfaces of slide guide face and bed of each press are hard scraped and provides smooth movement of slide square to the table geometrical alignment of I.S.I./ Prof. SCHLESINGER'S Limits of accuracy.
CLUTCH AND BRAKE:
A heavy duty dynamically balanced single disk combined clutch and brake unit is used for a continuos jolt free strokes and reduce noise. One board mounting provides easy accessability for maintenance.
PRESS LUBRICATION:
All presses are equipped with centralized one shot lubrication system to all important points.
ELECTRICAL:
All standard make electricals are used and are simple and safe. Provide complete safety for machine and operators.
OPTIONAL ACCESSORIES:STANDARD ACCESSORIES:
Hydraulic overload safety.Main motor control panel.
Pneumatic die cushion.Shot lubrication device.
Motorized lubrication device.Knockout bar (Mechnical).
Photo electrical safety device.Production counter.
Auto die Clamps.Dual Solenoid Valve (Above 100 ton).
Die Lifter.Three way rotary cam limit switch.
Quick die change system.Operation : Inching single cycle and Continuos cycle.
Variable speed.
Coil and strip feeder.
Inclinable mechanisms.

Facebook